• 2015年4月12日 11:49 点石



    这是3D打印的测试文件,
    当你不知道打印机状态是否适合打印一些复杂结构文件的时候,你可以运用这些测试文件来检查打印机的状态。
    赶紧试试你的打印机是否能够正确打印这些模型吧!

    This is a hard to print testfile!
    often you don't know if your printer is ready for complex files. with this file you have an easy option to check problematic printing/slicing stuff.
    does your printer challenge this ultimative part?
    check it out and get (almost) instant results.

    these test are included in this tiny file:

    尺寸: 底盘 4x50x50mm (baseplate)
    孔尺寸: 3 holes (3/4/5mm)
    螺帽尺寸: M4螺母
    打印清单: pyramide, cone, all numbers
    rounded print: wave, half sphere
    两面墙结构最短间距: 0.1/0.2/0.3/0.4/0.5mm
    悬垂角度: 25°/30°/35°/40°/45°
    bridge print: 2/3/4/5/6/7/8/9mm
    面: 全部都是平面体

    一般都会出现很多问题,这里列出一些常见错误:

    1.your printbed is not leveled (should be better than layerheigth you're printing, e.g use a Micrometre)
    2.your axis (Y/X/Z) clearence (with higher speed you also get problems with the moving mass)
    3.your slicer and configuration (every slicer handles things different and could contain bugs)
    4.retract settings (not correctly set you will see blobs or holes on every retract position)
    5.过高温度 to high temperature (small details will get overheated)
    6.打印速度错误, to reach this time, your printer should run between 60-200mm/s, infill as fast as possible. not every printer works in this range, so try to figure out where you're printer limit is.

    帖子3D模型附件,点击图片预览下载
    ctrlV_3D_test.stl 文件名称:ctrlV_3D_test.stl
    文件大小:1.33 MB
    文件格式:stl[ascii]
    顶点数:3319
    三角面数:6746
    下载模型


    为保证原文意思,错误情况未作翻译

    图片 3d模型 打印 打印机 printer

  • 很實用,不錯
    lzx 2015年11月28日 23:30
  • 亲,登录后才能发表回复哦~